How to distinguish the good from the bad

2020-12-08 17:30:32

Because most of the production workshop environment of plastic hanger factory is bad, if the anti-interference level of the machine is low, there will be electronic ruler jumping, machine program disorder, misoperation, crash and other phenomena, which will directly affect the quality and output of plastic clothes hanger.

The meaning of dipping plastic clothes hanger is plastic clothes hanger, which is mainly made of plastic clothes rack by the process of soaking plastic machine. Because most of the production workshop environment of plastic hanger factory is bad, if the anti-interference level of the machine is low, there will be electronic ruler jumping, machine program disorder, misoperation, crash and other phenomena, which will directly affect the quality and output of plastic clothes hanger. In this case, what are the aspects to judge the quality of plastic coat hanger and how to calculate a qualified plastic hanger?

Of course, the quality inspection of plastic hanger is mainly through naked eye investigation. After analyzing the current situation of the surface of the hanger, whether it is qualified or not usually includes the following aspects:

1. Whether there are coke marks on the surface, which is caused by the data differentiation caused by too high temperature

2. Mixed color, including miscellaneous spots, black or thickened stains, is certainly not impossible to appear, but it must not exceed 4 spots, and the area should not be too large or concentrated.

广东浸塑衣架

3. The problem of water mark, including water mark and water mark. The "in" pattern refers to the streaks in the plastic hanger that look like a dry river, while the "water mark" refers to the lines that dissolve together at the front end of the cold material.

4. Bump and concave point refer to the uneven and unsmooth plastic hanger.

5. Fog point problem, this means that the surface of plastic clothes hanger is clear after it is produced, but there are some fuzzy points in some places.

6. Scratches, of course, are not clear. Some of them are normal, but the length and width should not be too long, that is to say, they should not be too obvious.

7. Investigate whether there is shrinkage phenomenon of the dip coat hanger. It can be seen that there is no obvious water mark from 45 to 90 degrees, and there is no depression when touching.

Of course, the investigation of dip plastic hanger is usually from the front and back, from the top down, not directly from the bottom up, so if only from the bottom to the top, there is such a small defect, this is nothing, the same belongs to qualified products, no hanger factory can guarantee that the plastic hanger has no problem. in general. Dipping clothes hanger is mainly to investigate the appearance quality and scale of fine type, as for some physical and chemical properties can not be identified only from the naked eye.

Source: Guangdong dip plastic clothes hanger http://www.zm-yj.com/


Navigation Call About Product